Dual RJ45 Network wall mount box

Description

If your inverter has a single port called BMS 485/CAN you need to split out the communications for the BMS and the SmartDeyeDongle to 2 seperate RJ45 Ports.

Inside of the case is clearly marked with colours. Follow the B-standard

RS485 – Orange & Brown wires =  (pin 1,2,7,8) It is important that these 4 wires are disconnected from the battery as the battery might send signals that corrupts the signal.

CAN – Blue wires =  (pin 4,5)

The same can be achieved without a network box by cutting up a network cable.

You need to split the port on the following models:

1. The newer Single Phase 5kW, 10kW, 12kW, 16kW and the 15kW split Phase
2. Most Three Phase Low Voltage inverters with the modebus port (you might be lucky and the modebus might work for writes on your firmware)